PROJECTS

Regal Mold and Die completes many projects each year in the automotive, healthcare, appliance, and electronics industries (Click on picture for larger view).

2-Shot Motor Holder
2-Shot Motor Holder

press to zoom
Joint Duct
Joint Duct

press to zoom
Gear Plate System
Gear Plate System

press to zoom
2-Shot Motor Holder
2-Shot Motor Holder

press to zoom
1/7
HVAC

Our most prominent project. We make both single and two shot HVAC parts that are top quality.

Pressure Tanks (Upper/Lower)
Pressure Tanks (Upper/Lower)

press to zoom
Cooling Fan
Cooling Fan

press to zoom
Pressure Tanks (Upper/Lower)
Pressure Tanks (Upper/Lower)

press to zoom
1/2
Radiator

 

Our radiator projects include, but are not limited to, cooling fans and pressure tanks.

Center Panel
Center Panel

press to zoom
2-Shot Cupholder "Rollo Door"
2-Shot Cupholder "Rollo Door"

13 individual hard plastic segments with rubber molded over the top.

press to zoom
Center Panel
Center Panel

press to zoom
Center Panel
Center Panel

press to zoom
1/6
Automotive Interior

We create a wide variety of molds for parts in the interior of automotives. Including, but not limited to, center panels, speaker gilles, and storage bins. We create both 2-Shot and Applique molds.

Food Scoop
Food Scoop

press to zoom
Chemistry Slide Container
Chemistry Slide Container

press to zoom
Food Scoop
Food Scoop

press to zoom
1/2
Multi-Cavity

We complete these molds in the healthcare and other industries. 

Headlight Closeout
Headlight Closeout

press to zoom
2-Shot Headlamp/Taillamp Closeouts
2-Shot Headlamp/Taillamp Closeouts

press to zoom
2-Shot Headlamp/Taillamp Closeouts
2-Shot Headlamp/Taillamp Closeouts

press to zoom
Headlight Closeout
Headlight Closeout

press to zoom
1/3
Automotive Lighting

 

Our automotive lighting projects include single and two shot molds.

Sensor Connecter
Sensor Connecter

Overmolded and Insert Molded using PPS Material. Mold runs at 280 degrees F.

press to zoom
Wire Trough
Wire Trough

press to zoom
Sensor Connecter
Sensor Connecter

Overmolded and Insert Molded using PPS Material. Mold runs at 280 degrees F.

press to zoom
1/2
Automotive Under the Hood

Our automotive projects for under the hood parts are both 2-Shot and Insert Molded.

Various Small Parts
Various Small Parts

press to zoom
Thumbwheel
Thumbwheel

press to zoom
Thumbwheel
Thumbwheel

press to zoom
Various Small Parts
Various Small Parts

press to zoom
1/5
Smaller 2-Shot Parts

 

These parts include register thumbwheels, small closeouts, and drain tubes.